Patriotp80builder
New member
- Joined
- Oct 28, 2025
- Messages
- 11
- Reaction score
- 2
- Points
- 3
Hey, noticed that my right trigger housing pinhole seems to be slightly too low. I actually found this out by insterting my M3 drillbit from the left to right, and noticed the right hole was out of spec, as I couldn't push the bit through the hole. Can I simply just drill out the polymer thats blocking the drill bit? Plan to do this leaving the left hole alone and putting the drillbit through there to just contact and remove the remaining polymer on the right hand pinhole.
I've ruled everything else out. Tried two separate rails and my housing is correct (Gen 3 housing with G5 ejector)
Two photos below showing drillbit in pinhole
Photo showing how pinhole looks with the pin, trigger housing and rails in. Shown below.
I've ruled everything else out. Tried two separate rails and my housing is correct (Gen 3 housing with G5 ejector)
Two photos below showing drillbit in pinhole
Photo showing how pinhole looks with the pin, trigger housing and rails in. Shown below.
