Pin Too Loose?

[DisGuyLolLmao]

I put in the lower parts for this build and turns out this pin is loose. The picture is not mine and only provided for reference as i am not home. I drop tested it and the pin doesn't come out, but when i give it a light push with the pin pusher tool it slides out with little to no resistance. Any tips?

 

[Callducks7]

Are the holes for the locking block pin round? I had a buddy with this problem on a Glock. If they are just loose I fixed his by coating inside of holes with super glue.
Clean out the hole good with rubbing alcohol first.
Put a tiny drop of glue on a big needle or very small nail and run it around inside both holes. It took a couple of applications. Make sure it is completely dry.
If you get too much just clean out the hole with your 3mm drill bit by hand.

 

[Michele]

“Glue” the pin in with Nail polish, it’ll stay til you want to push it out

 

[Callducks7]

Coral will look nice.

 

[Michele]

Well I suggest clear, but whatever floats your boat

 

[Mooner]

View: https://www.youtube.com/watch?v=t2CW_xp7L-I

 

[Racer88]

Coral will look nice.

Well I suggest clear, but whatever floats your boat

Could be a whole new trend! Maybe that's what dimpled pins are for!

 

[DisGuyLolLmao]

Would plastic dip work aswell?

 

[Callducks7]

Would plastic dip work aswell?

No, that only works with polymer chips.

 

[Michele]

Would plastic dip work aswell?

Yes it should however, not sure if having to remove and reapply each time the weapon is field stripped to clean is feasible

 

[Racer88]

No, that only works with polymer chips.

Ha! Took me a bit to "get it."

Don't you know there's a shortage of chips?