Theme Gun Darth Vader 45

MikedaddyH

MikedaddyH

Mega-Patriot!
Exchange Privileges
Top Poster Of Month
Joined
Jul 23, 2024
Messages
2,106
Reaction score
2,486
Points
168
This is the gun which was started in a different thread. Glock20/21SF frame.
I ordered a KMTactical Slide yesterday in Stormtrooper White. Also Ordered pins , slide lever release, mag release and slide stop in Stormtrooper White. Darth Vader slide back plate is in the mail. I already have Glock OEM parts for the frame and slide. A Lone Wolf striker, Ghost 3.5lb connector, G#350 spring (6lb) , G#64 spring (4lb) and a reduced pressure spring on the firing pin safety. This is a good combo.
Just need to order a barrel, RMR sight, recoil spring and a trigger housing. It should be finished in September.
 
MikedaddyH said:
This is the gun which was started in a different thread. Glock20/21SF frame.
I ordered a KMTactical Slide yesterday in Stormtrooper White. Also Ordered pins , slide lever release, mag release and slide stop in Stormtrooper White. Darth Vader slide back plate is in the mail. I already have Glock OEM parts for the frame and slide. A Lone Wolf striker, šŸ‘» 3.5lb connector, G#350 spring (6lb) , G#64 spring (4lb) and a reduced pressure spring on the firing pin safety. This is a good combo.
Just need to order a barrel, RMR sight, recoil spring and a trigger housing. It should be finished in September.
Click to expand...
MKII slide or one of the others? Watch the Lone Wolf striker as the ones they sent me had defective chrome and it chipped off after very little use.
 
Last edited:
FrankenGlock said:
MKII slide or one of the others? Watch the Lone Wolf striker as the ones they sent me had defective chrome and it chipped off after very little use.
Click to expand...
Like I said before that I have used Lone Wolf Strikers and Extractors before with good results. But I will keep an eye on the finishing of the plating.
 
The slide is KMT Cerakote RMR bullnose with two port cuts in the top.
 
You are building a G21? LW Slides, extractors, and barrels are fine. They have some really nice, polished billet extractors that I use.
 
Last edited:
Got the Cerakote pins and mag release SS &SRL in the mail today. Just not worth putting any parts on till I got the trigger housing. I will take a picture after that.
 
IMG_20240822_181753_HDR.jpg
I received some parts today in the mail. Just put the frame together. Did a rough buff of the trigger bar. Then assembled it with a G350 , 6lb spring and a 3.5lb Ghost connector. Storm Trooper White pins and levers..
IMG_20240822_181735_HDR.jpg
 
Going to go to Wally World or Walgreens to get a nail file . It's my go to tool !
 
This trigger pull is smooth ! I haven't polished it yet. šŸ¤Æ Very light touch.
 
Last edited:
I hit the trigger arm with 280 grit then 320 grit and then the polishing wheel. It is soft ... I don't have a trigger pull gauge but I would guess 3 to 3.5 lbs. I didn't touch the connector it already is polished.
 

Share this page

Back
Top