Theme Gun Darth Vader 45

Gen3SF frame KTM slide G40 in 10 mm
IMG_20240910_124518_HDR.jpg
 
I received an RMR optics from Amazon and mounted it today. Should get fiber optic Front and Rear sights tomorrow. Only waiting for mag to come in. Will get another picture after the sights get mounted. Almost ready to shoot , can't wait!!!
 
Got my fiber optic sights today and will install them on the gun in a little while. I am down to magazines and a 20 lb RSA.
 
IMG_20240919_181906_HDR.jpg
 
Gathering the final parts for the second build . Just need the trigger and extractor to make it functional. Also an RMR. Got a SS guide rod , installed a 22# spring on Friday along with a TiN 10/45 firing pin. The extractor is in the mail. I still need to order the trigger, I was going to put a shoe on the lever I have but ... OC Triggers is calling for me again.
 
IMG_20240929_082929_HDR.jpg
KMTachtical 40 Slide, Go to Gear SS Rod, Wolff 22# spring.
IMG_20240929_082947_HDR.jpg
 
IMG_20240929_084300_HDR.jpg
 
IMG_20240929_085228_HDR.jpg
 
Is that a captured Gen 4 to gen 3 RSA adapter or loose? If loose, I had to flatten one side of the adapter so it didn't interfere with the barrel when it is cycling. Have you placed it on the frame and tried to cycle yet?
 
Last edited:
Cheap Magwell that I had to take the lip off of so factory mag would fit properly..I have some aluminum dye which will used later.
IMG_20240929_085739_HDR.jpg
IMG_20240929_085806_HDR.jpg
 
I received the 10mm extractor today and installed it on the slide. I only need one part, the trigger. The build is getting close to being finished.
 

Share this page

Back
Top