26x

[FrankenGlock]

Have some SCT 19 frames sitting around and have too many 19’s so I decided to convert one to a 26x. Since the G26 has a Gen 4 sized nose and the SCT is Gen 3 sized frame, you have to clearance the inside of the frame. You also have to remove a small bit of the rails for clearance and below the rails so the nose can sit right next to it when cycling. This one is running a Gen 5 trigger bar, housing, and Lone Wolf competition connector. Zaffiri made slide and barrel with single spring RSA and billet internals.

 

[Bobster]

 

[FrankenGlock]

Lot of this too.

 

[brian]

Looks good! What sort of polishing/cleanup did you do on the portion that was cut?

 

[FrankenGlock]

Looks good! What sort of polishing/cleanup did you do on the portion that was cut?

Chop off part of the front and plastic weld it back up to match the profile of the slide nose. Inside, had to clearance for the slide nose and larger RSA. Grind and contour the front rail material so the slide could go far enough back to cycle and lock back. This one was more difficult than the 19xx I made a few weeks prior with a Geisler 19x frame.

 

[FrankenGlock]

Family portrait.

 

[Rocky Decatur]

Dude that is awesome work, and nomad defense just dropped their 26X frame too. That being said ... was it just the tip? ( cmon someone was thinking it)